Polished Concrete Basement
Our planetary grinders weigh a minimum of 650 pounds and require a clearance of at least 30 in. In order to complete a basement job, access is critical. The slab was ground and polished to 1,500 grit. Densifier was applied after a 200 grit pass. A lithium silicate guard was applied and then the slab…
Shuffleboard
After several years of exposure to the weather and pine trees, this shuffleboard needed some attention. After grinding the court to clean concrete and starting the honing process, a stencil was placed on the slab, and stain and densifier were applied. The court was polished to an 800 grit finish, and a guard was applied.…
Polished Concrete Retail Space
Before and after shots of a job In Melrose, Massachusetts. The new concrete slab was not left with a smooth trowel finish. Additional/extra grinding was necessary to get ridges out of concrete. The slab also had numerous cracks and spalls which required repairs. The slab was polished to an 800 grit finish. Densifier was applied…
Aircraft hangar
The epoxy on the slab of a 12,000 square foot airplane hangar in Nashua, NH needed to be replaced. This project was on a tight schedule because the airplanes in the hangar had to be moved and stored in a rented hangar. To get to clean concrete, approximately 1700 lbs of epoxy and concrete were…
Generator Superstore
Generator Superstore – Stratham, New Hampshire – This slab is located in a strip mall that was constructed approximately 30 yrs ago. The customer requested a black diamond graphic, centered in the front (retail) portion of the unit. Measurements were taken and temporary protection was set up. Stain and densifier were applied, and the slab…